в корзину

Корзина покупок
 

Набор для 3D принтера MKS Gen V1.2.2

Набор для 3D принтера MKS Gen V1.2.2
Набор для 3D принтера MKS Gen V1.2.2
Модель: 3D0101
Можно купить (штук): Нет в наличии (ожидается)
По цене: 142.00 бел руб

"Characteristic advantage: 1. Integrate 2560 and ramps 1.4 into one board, solving the problem of frequency failures caused by complicated combined interface of Ramps1.4. 2, Replaceable motor drive; support 4988 drive and 8825 drive. 3, the circuit board adopts high quality 4 layer plate and has undergone cooling optimization process; ramps is 2 layer plate. 4, Adopt high quality MOSFET tube with better cooling effect. 5, Adopt exclusive power chip, support 12V-24V power input, solving the fevering problem of Ramps voltage converting chip. 6, Accept 24V input; the hotbed current can be reduced to 1/4 under the same system power, effectively solving the fevering problem of hot bed MOS tube. 7, the firmware can use the open source firmware Marlin and the configuration is the same with that of ramps1.4, thus it can replace Ramps1.4 directly. 8, can be directly connected to Ramps1.4,2004LCD control board and 12864LCD control board. 9, reserved motor pulse and direction output port, easy to plug in the big current. 10, reserved Servos, AUX-1, AUX-2 interfaces on Ramps, provide three 5V outputs and three 12V output interface."

Написать отзыв

Ваше имя:


Ваш отзыв: Примечание: HTML разметка не поддерживается! Используйте обычный текст.

Оценка: Плохо           Хорошо

Введите код, указанный на картинке: